Rates
Camera Install, mounting, program, setup (Fixed) $95.00
Camera Install, mounting, program, setup (Network) $150.00
Camera Install, mounting, program, setup (PTZ) $220.00
Camera Adjusting, cleaning (no mounting, no moving) $40.00
Change existing connectors, each $15.00
DVR Install, Network Setup, Training, 4 hour limit $480.00
Assemble / Install / Connect Rack – small up to 12 u $295.00
KVM Install and wiring $145.00
LCD Wall Mount and connection (without wall mount) $145.00
Wire runs – Cat5e Standard to 75 ft – terminated $95.00
Wire runs – Cat5e Standard to 150 ft - terminated $125.00
Wire runs – Cat5e Standard to 225 ft - terminated $195.00
Wire runs – Cat5e Standard to 300 ft - terminated $214.00
2 Wire runs-Phones/ Network Cat5e Standard to 75 ft $135.00
2 Wire runs-Phones/ Network Cat5e Standard to 150 ft $195.00
2 Wire runs-Phones/ Network Cat5e Standard to 225ft $245.00
2 Wire runs-Phones/ Network Cat5e Standard to 300ft $295.00
Wiring in steel ½ inch pipe conduit additional $ 2.00/ft
Wiring in Molding or Flex additional $ 3.00/ft
Fishing inside a wall $ 55.00/h
Certify Data Wire Run with Print Out – Each. $15.00
Phone repair Labor Rates (per hour) $95.00/h
CCTV repair Labor Rates (per hour) $95.00/h
Data repair Labor Rate. May vary 95.00/h
Phones install Labor Rates $65.00/h
Travel charge ($2 per mile from our main office) $2.00 per mile
Price is based on the scope of work as provided to GSS by the customer. If the required / actual scope of work is different from the scope of work, as provided, the quoted price is subject to change.
Prices are based on the following job assumptions and requirements.
1. Any and all additional work is extra and will be charged according to our price list or T& M if not listed.
2. Work to be performed during normal working hours – 8 AM to 5 PM local time and standard office environment.
3. Standard office environment – drop ceilings, limit 9 ft height, accessible interior and exterior walls, unrestricted access to equipment and jack locations
4. Technician is not required to move or relocate desks, shelving or other equipment.
5. Non-standard locations will incur additional charges. All equipment and CO lines / circuits available at time of installation.
6. Any missing equipment and/or equipment failures may require additional visits(s), which will be billed at the normal T & M rate, plus a visit charge per occurrence.
7. AC power, ground location and backboard available, if required.
8. All wiring is non-plenum unless otherwise stated.
9. Programming prices based on customer providing accurate support and documentation at time of installation.
10. Training prices based on customer being available for initial training session. Additional sessions are extra.
11. Additional time / visits due to service provider problems or delay will incur additional charges.
Quotes for Circuit turn-up and testing are limited, delays due to LEC problems are billable per hour
